Instructions

Below you will find instructions for various products, as needed.

Decal Vinyl application windows (NOTE: there are two sets of instructions A & B)

Below is the small print on the back of the decals, where there was room.  I placed it here for easier reading. 

A.   First decide where you want it placed.  If you have an Inside decal, you will place the decal from the inside window and it will face out.  If you have an outside decal, you can just look at it from the outside.  It will be helpful to have someone to help you line it up.

​Application: Best when surface temperature between 50°F and 90°F. 

Preparation: Wash and rinse the area with liquid dish detergent and warm water. Then dry the surface with a clean lint free towel or cloth.  Wipe down the entire area with Isopropyl Alcohol (rubbing alcohol) and let dry. To avoid recontamination during the final cleaning step, wipe the surface in just one direction, using a clean, lint free towel or cloth.

Remove backing, being careful to make sure the letters don't lift.  You should now have letters on the clear transfer tape.  Turn it around and carefully place it where you want it.  DO NOT let it touch the surface until you have it lined up.  You probably won't get it off without ruining it. Do not touch sticky side with fingers.
Use a credit card or something similar to rub against it and then slowly lift clear tape at a 90 degree angle, make sure all letters stay on your window.  You can help letters release with a pin or tweezers.

Disclaimer:  Your Celebration Solutions LLC will not be held responsible for any damage caused by your application of decals. 

Always check your with a specialist before using any type of chemicals, cleaners and removal tools such as razors on any type of surface, including painted and glass.
Disclaimer:  Your Celebration Solutions LLC will not be held responsible for any damage caused by your application or removal of decals. 

Below is how to remove a decal from glass. Find our shop on our Facebook page


B. Application:  Best when surface temperature between 50°F and 90°F. 

Preparation:  Wash and rinse the area with liquid dish detergent and warm water. Then dry the surface with a clean lint free towel or cloth.
Apply rubbing alcohol (Isopropyl) over the entire area, let air dry.  Shouldn't take very long.

Application Tips:  Do not apply in cold weather or extreme heat.  Cold It may stick at first, but may lift. Heat it may stretch. 
Do not apply to dirty, oily or waxy surface.  Do not use window cleaner or other ammonia type cleaners.  Do not apply wax over graphics, especially if the wax contains any petroleum.  Do not touch the adhesive backing. The oils from your skin will prevent it from sticking.  Do not use an ice scraper on the decal which can cause it to lift.

Removal:  Begin by heating one corner of the marking with a blow dryer, heat lamp, hot water or heat gun until hot to the touch.
Pick up and lift that area you just heated (very carefully use a razor on glass surfaces). Slowly begin pulling back the decal, at less than a 90 degree angle. Continue applying heat to the area just before the area that is being removed.
Once you have removed the marking, check to make sure that all of the adhesive residue has been removed. Remaining residue may be removed by using Isopropyl alcohol (rubbing alcohol).   

Always check your with a specialist before using any type of chemicals, cleaners and removal tools such as razors on any type of surface, including painted and glass.
Disclaimer:  Your Celebration Solutions LLC will not be held responsible for any damage caused by your application or removal of decals.